HP DesignJet 650C on Windows 7 x64 via LAN with JetDirect Adapter
Post Options
10-27-2013 08:15 AM
With a JetDirect card installed in the 650c do the following:
Connect the 650c to your router with a LAN cable. Next, on the front panel press Enter, then down arrow three times to get to I/O Setup, Enter, Modular Setup, Enter, Cfg Network=NO, Enter, uparrow to Yes, Enter. At this point theCfg Network=NO* will reappear, this is normal. Press Previous to return to the main status menu. Next press Enter, down arrow until you get to Utilities, Enter, down arrow to Config Plot, Enter. Once the plot finishes look about half way down the page for the MIO setup information, the IP address for the plotter will be available on the right side of the page.
At this point your plotter is configured and ready, next get the driver installed on your PC. You can install the XP x64 drivers as described in this post, these drivers work fine for Windows 7 x74 (and also Windows 8 x64).
Post Options
10-27-2013 08:15 AM
With a JetDirect card installed in the 650c do the following:
Connect the 650c to your router with a LAN cable. Next, on the front panel press Enter, then down arrow three times to get to I/O Setup, Enter, Modular Setup, Enter, Cfg Network=NO, Enter, uparrow to Yes, Enter. At this point theCfg Network=NO* will reappear, this is normal. Press Previous to return to the main status menu. Next press Enter, down arrow until you get to Utilities, Enter, down arrow to Config Plot, Enter. Once the plot finishes look about half way down the page for the MIO setup information, the IP address for the plotter will be available on the right side of the page.
At this point your plotter is configured and ready, next get the driver installed on your PC. You can install the XP x64 drivers as described in this post, these drivers work fine for Windows 7 x74 (and also Windows 8 x64).